The accessories authorize via original ATSHA204 keys. Third party support seems active although the developer program has been mothballed years ago. Parakeet - The drone and gimbal interface seems abandoned. 'Klingon' is still in its infancy so it's unknown what this accessory does. The Slimport will pass though the unused superspeed pair over the USB-C bus and coverted to HDMI via an Analogix receiver. Speculatively a Cypress USB-C PD, ATSHA204 and a Pericom USB BC2.1 switch. The Media Mod 'Borg' will communicate to an external Conexant CX20811 ADC. Not sure if they will expose this to the end customer, but it is in the firmware. This means you don't need external device such as CamDo Blink-x to do super long time lapse. GoPro did fix the wifi password generation schema with now 57^16 combinations of passwords! First shipment does not have the new scheme so you will have to re-connect your camera once it goes to 1.20.00 as the password has changed. (LCE) Lens la068aĬhem-ID 0x3948 TI Fuel Gauge type '3' Possibly: BQ27Z561-R1 'Ultra Low Power Always-On Voice Activation for Any Device' Protecting against bad chargers, detecting power, usb pin muxing. Still authenticates Battery and SHA204 as before USB-C PD / Accessory Sentinel / Battery authentication / Reset Handler / RTC Touch Panel Controller with display produced by JDI, NVD or US Micro Believe this allows them to boost the clock of the system. PMIC Dedicated 0.9v regulator for VDDCore and possibly LDDR of GP1. PMIC (Power Management IC) for Socionext.

SlimPort transmitter for Display Port over USB-C GPS Receiver u-blox M8 GNSS chip, WL-CSP47, Standard grade Sensor 12MP 44fps max full res, 1/2.3, 1.55 pixel size, SLVS-EC 8Lane High performance, low power single-stream 11ac MU-MIMO and Bluetooth 5 in a single chip solution. GoPro HERO used BHA250 hub and BMI160/BMG250. Lens protectors and snap on PolarPro lenses available shortly.Ĭortex A7 hardware Floating Point / CEVA DSP / Cortex M0 coprocessorĪccelerometer / Gyro pair 6-axis sensor. 17% lighter and smaller (when compared to HERO7 with the frame).Fiberglass or some woven technology enclosure.

The battery may have a higher discharge rate or temperature tolerance. This allows them to 'boost' the processor / LDDR. New power subsystem including yet unknown change to battery.However small changes in hardware can make huge impacts on the system reliability and stabilization. No significant electronic differences between the HERO7 and the HERO8. A quick summary of the design wins for the GoPro HERO8 (J-Bay).

Quik gopro disable hilights